JETT•PACK® Temperature Module

The JETT•PACK Temperature module measure temperatures using platinum resistance thermometers (PRTs).  The common industry standard PT100 is supported.  PT100 Class A sensors have an accuracy of +/-0.15  C. Changing sensor probes to allow measurement of different surfaces or materials does not require re-calibration of the Temperature Module.

Accuracy and Resolution
Although accurate temperature sensors are widely available, it has been difficult to take advantage of them due to errors caused by the measuring device.

 The JETT•PACK Temperature module however, is inherently accurate due to its novel design. Rather than relying on voltage references (which tend to be temperature sensitive), it uses 'reference' resistors which are extremely stable (low temperature co-efficient and drift). To achieve the 0.01 C resolution, a state-of-the art ADC is used that can resolve to better than 1 part in 65 thousand.

Probes are available for specific requirements including:

• Air probe high temperature
• Air probe heavy duty
• Air probe fast response
• Immersion probe
• Insertion probe

Software
A software driver is provided for the JETT•PACK Temperature Module. There is a simple driver that can be integrated into your applications software.
 

Sensor             PT100
Range             -100 C to +200 C
Accuracy         0.01 C -  At 0 C
Resolution       0.01 C
Connector       Mini DIN 4 pin

Two Technologies assumes no responsibility for, and disclaims all liability for, the content of any off-site pages. All companies listed on this page are independent from Two Technologies and all product support and service inquiries should be directed to the appropriate company.

Copyright ©2007 Two Technologies, Inc. All Rights Reserved.
Return to www.2T.com